Trenchless Sewer Repair — CIPP Pipe Lining Without Excavation

Delex Plumbing installs trenchless CIPP sewer lining throughout Mississauga — repairing cracked, root-invaded, and deteriorated sewer laterals from the inside without excavating your yard or driveway. 50-year design life lining. Camera before and after every installation.

What Is CIPP Trenchless Sewer Lining?

CIPP (Cured-In-Place Pipe) lining is a trenchless sewer repair method that installs a new pipe liner inside an existing deteriorated sewer pipe — from the access point, without any excavation. The liner is a felt tube saturated with epoxy resin. It is inserted through a clean-out or toilet connection, inflated against the interior of the existing pipe using a bladder, and cured in place with hot water or UV light. When cured, the liner forms a structurally independent pipe inside the host pipe with a smooth inner surface and a 50-year design life.

CIPP lining is applicable to residential sewer laterals with root intrusion, cracked pipe sections, deteriorated joints, and minor offset — as long as the pipe has not collapsed to the point where the liner cannot be inserted and inflated. A pre-lining camera inspection confirms whether the lateral is a candidate for lining or requires excavation and replacement.

The lining process leaves the host pipe in place — the clay, cast iron, or deteriorated PVC remains in the ground, and the new liner is formed inside it. This eliminates the disruption, cost, and surface restoration associated with full lateral excavation while delivering a pipe that is structurally equivalent to a new installation in most respects.

CIPP lining is the most cost-effective long-term solution for Mississauga sewer laterals with confirmed root intrusion in structurally sound pipe. It eliminates root re-entry by sealing all joints in the lined section, replacing the 12 to 18 month root-cutting cycle with a permanent barrier. The typical installed cost of CIPP lining is 30 to 50 percent lower than full lateral replacement for the same lateral length.

Ontario Building Code permits CIPP lining as a compliant repair method for sewer laterals — it is not a temporary patch but a recognized structural repair that satisfies the same code requirements as pipe section replacement. We obtain the required permit from the City of Mississauga Building Department for trenchless lining projects and arrange the pipe-in-use inspection after lining completion. The signed inspection certificate is provided to the homeowner for the property record.

CIPP Lining vs. Excavation — Choosing the Right Repair

CIPP lining is appropriate when the camera shows root intrusion, minor cracking, or deteriorated joint seals. We hydro jet the lateral before lining to remove all root mass and grease so the liner adheres properly. For pipes requiring sewer line repair at collapsed or severely displaced sections, we address those by excavation before lining the remaining run.

Excavation and replacement is required when the camera shows: complete pipe collapse that cannot accept a liner, severe pipe offset that prevents liner insertion, pipe sections that have decayed to the point where the wall thickness is insufficient to anchor the liner, or when the lateral depth and configuration do not permit trenchless access. We advise clearly on which approach is appropriate for a given lateral condition after the pre-repair camera inspection.

For laterals with mixed conditions — sound sections and defective sections along the same run — a combination approach is often the most cost-effective: spot excavation and replacement at the defective section, lining of the sound sections. We design the repair scope based on the camera findings rather than defaulting to a single method for the entire lateral.

The surface restoration advantage of CIPP lining is significant for Mississauga properties with mature landscaping, finished driveways, or garden features along the lateral path. Avoiding excavation of a 15-metre front yard with established landscaping can justify the trenchless approach on its own, independent of the pipe repair cost comparison.

The CIPP Lining Installation Process

Pre-lining hydro jetting cleans the pipe wall to bare material — removing all root mass, grease, scale, and debris. The liner will not adhere to a contaminated pipe wall, so thorough hydro jetting is the prerequisite for a successful CIPP installation. We confirm wall cleanliness with a post-jetting camera pass before liner insertion begins.

Liner sizing requires measuring the exact internal diameter of the host pipe at the access point and along the run. An undersized liner does not make full contact with the host pipe. An oversized liner cannot be inserted. We measure with the pre-lining camera and confirm sizing before ordering the liner material for the specific job.

Liner insertion uses an inversion drum or pull-in-place method depending on the pipe depth, length, and access configuration. For most residential Mississauga laterals (8 to 20 metres in length, accessed from the basement clean-out), inversion is the standard method. The liner is inverted through the access point and pushed by air pressure to the end of the lined section, where a calibration tube is inflated to press the liner against the host pipe wall during the curing process.

Curing time depends on the cure method. Hot-water cure takes 2 to 4 hours. UV cure takes 30 to 60 minutes. After curing, the bladder is deflated and removed, and a post-lining camera confirms the liner has set correctly with a smooth, round bore throughout the lined section. Any mis-set section is re-lined before the job is considered complete.

Service reconnections after lining require reinstating any branch drain connections — where branch drains from additional fixtures join the lined lateral, the liner covers these connections and they must be cut open after the liner cures. We perform this service reconnection using a robotic cutter or manual cut from the access point, reopening each branch connection to its original diameter before the post-lining camera confirms all connections are fully open.

For Mississauga homeowners whose property has both a clay main lateral and a cast iron branch drain stack connecting to it, CIPP lining can address the clay lateral while the cast iron stack is assessed separately. We provide a condition assessment of the full drain system visible from the camera access point — not just the lined section — to give homeowners a complete picture of their drain system health after the lining project is completed.

CIPP Lining Cost and Warranty

CIPP lining for a typical Mississauga residential sewer lateral (10 to 18 metres) costs $4,500 to $9,500 — approximately 30 to 50 percent less than full lateral excavation and replacement for the same length. The exact cost depends on the lateral length, diameter, depth, and the access configuration at the lining entry point.

We provide a written warranty on CIPP lining installations: a 10-year warranty on the installation workmanship, and the liner manufacturer’s 50-year warranty on the liner material itself. The post-lining camera video is provided to the homeowner as permanent documentation of the installation quality for warranty reference and future comparison inspections.

The Peel Region Flood Protection Subsidy does not currently cover CIPP lining specifically, but lateral lining that is performed in conjunction with a backwater valve installation may qualify for the subsidy on the valve component. We advise on subsidy eligibility during the pre-repair consultation. Call 416-910-2550 or request service to schedule a free camera inspection and trenchless lining assessment.

Free Estimate — Call 416-910-2550

Every trenchless sewer repair starts with a free camera inspection and written estimate. Call 416-910-2550, contact us online, or request service

Frequently Asked Questions

Q: How long does CIPP sewer lining last?

A: The liner material has a manufacturer-rated design life of 50 years. The lining creates a structurally independent pipe inside the host pipe and is resistant to root re-entry because it seals all joints in the lined section. With proper maintenance of the portions of the drain system outside the lined section, a CIPP lining should perform for the rated service life without further intervention.

Q: Does CIPP lining reduce the pipe diameter?

A: CIPP lining reduces the internal diameter of the pipe by approximately 6 to 12mm (the wall thickness of the liner, which varies by pipe diameter and liner specification). For a standard 100mm residential lateral, the lined internal diameter is approximately 90 to 94mm. This reduction in diameter does not significantly affect flow capacity in residential applications.

Q: How long does CIPP lining installation take?

A: A typical residential lateral lining (10 to 18 metres) is completed in one day — hydro jetting, liner insertion, and curing. Hot-water cure takes 2 to 4 hours after insertion. UV cure takes 30 to 60 minutes. The home is back in service the same day in most cases.

Q: Can CIPP lining be used on any pipe material?

A: CIPP lining is applicable to clay, cast iron, PVC, concrete, and most other drain pipe materials. The host pipe must be intact enough to accept the liner and provide a surface for the liner to set against. The pre-lining camera inspection confirms material, condition, and lining candidacy before we commit to the trenchless approach.

Get Your Free Estimate Today!

Or Give Us A Call: 416-910-2550

Licensed & Insured Trusted Local Plumbers

Fast Response Usually Within 1 Hour

Satisfaction Guaranteed 100% Quality Work